Alright all you scallywags and wanna be boaters we're going to start your knot tying education today. Just follow along with these simple knots and you will be able to secure your boat like a pro.

Two Half Hitches
Reliable knot is easy to tie for mooring, or docking.
You can also use this knot for tying the bumpers to your pontoon railing.


How to pull it off:
1. Pass the end of a rope around a post or other object.
2. Wrap the short end of rope under and over the long part of rope, pushing the end down through the loop. This is a half hitch.
3. Repeat on the long rope, below first half hitch, and draw tight.

Sheet Bend

Reliable knot for joining two ropes of any size.

Widely used knot for boating.

• Sheet Bend is for joining two ropes
• Use it when towing another boat, to tie your rope to theirs.

• Use it to make a quick repair of a broken or cut ski rope.

• Use it to tie extra rope to the anchor when a longer rope is needed.



Bowline

Does not jam or slip when tied properly.

Widely used by fire and rescue teams.




How to pull it off:
1. Make the overhand loop with the end held toward you, then pass the end through the loop. 
2. Now, pass the end up behind the standing part, then down through the loop again. 
3. Draw tight. 

Cleat Hitch
es
Two ways to tie a rope to a cleat.





Anchor Bend

This knot is used to secure a rope or a line to an anchor.




How to pull it off:
1. Pass two loops through a ring.
2. Place the free end around the long rope.
3. Pass the free end through loops.
4. Complete by making a half hitch.

Clove Hitch

An easy way to tie a rope around a post.
This knot can work loose, so it is best to finish off with 1 or 2 Half Hitches.




How to pull it off: 
1. Make a turn with the rope around the object and over itself.
 2. Take a second turn with the rope around the object.
3. Pull the end up under the second turn so it is between the rope and the object; tighten by pulling on both ends.

Figure Eight

This knot is for the end of a rope, so you can hold on.



How to pull it off:
1. Make an underhand loop, bringing the end around and over the standing part.
2. Pass the rope end under, then up through the loop.
3. Draw tight.

Whipping the End of a Rope

This will Bind the end of a rope.



How to pull it off:
1. Make a small long loop along the rope. 
2. Wind the line around the rope, close and tight.
3. Feed the end through the long loop that is exsposed.
4. Pull both ends of the line tight and also pull the two lines under the wrapped line.

Braiding a Loop with Twisted Rope

Now you can make your own docking lines
This does not have to be perfect.
Just weave each 
of the three rope ends one after the other till you get about 6" of braid.



For more knot tying advice you can check out this animated knot tying website it's easy to follow along and learn how to tie number of knots.

http://www.animatedknots.com/indexboating.php

Check out our boat rentals and jet ski rentals. We always have the best equipment on Lake Conroe.

Looking for some deep water to put your boat in this summer we have plenty boat slips rentals too.